Liquid Marble Patchwork on Super-Repellent Surface

Liquid marble (LM) is a droplet that is wrapped by hydrophobic solid particles, which behave as a non-wetting soft solid. Based on these properties, LM can be applied in fluidics and soft device applications. A wide variety of functional particles have been synthesized to form functional LMs. However, the formation of multifunctional LMs by integrating several types of functional particles is challenging. Here, a general strategy for the flexible patterning of functional particles on droplet surfaces in a patchwork-like design is reported. It is shown that LMs can switch their macroscopic behavior between a stable and active state on super-repellent surfaces in situ by jamming/unjamming the surface particles. Active LMs hydrostatically coalesce to form a self-sorted particle pattern on the droplet surface. With the support of LM handling robotics, on-demand cyclic activation–manipulation–coalescence–stabilization protocols by LMs with different sizes and particle types result in the reliable design of multi-faced LMs. Based on this concept, a single bi-functional LM is designed from two mono-functional LMs as an advanced droplet carrier.     

Fast microwave detection system for coherent synchrotron radiation study at KEK: Accelerator test facility

A fast room temperature microwave detection system based on the Schottky Barrier-diode detector was created at the KEK ATF (Accelerator Test Facility). It was tested using Coherent Synchrotron Radiation (CSR) generated by the 1.28 GeV electron beam in the damping ring. The speed performance of the detection system was checked by observing the CSR from a multi-bunch (2.8 ns bunch separation time) beam. The theoretical estimations of CSR power yield from an edge of bending magnet as well as new injection tuning method are presented. A very high sensitivity of CSR power yield to the longitudinal electron distribution in a bunch is discussed.     

Operation of superconducting fault current limiter using vacuum interrupter driven by electromagnetic repulsion force for commutating switch

Using conventional high‐temperature superconducting wire, a model superconducting fault current limiter (SFCL) is made and tested. Solenoid coil using Bi2223 silver sheath wire is so made that inductance is as small as possible and a vacuum interrupter is connected in series to it. A conventional reactor coil is connected in parallel. When the fault current flows in this equipment, superconducting wire is quenched and current is transferred into the parallel coil because of voltage drop of superconducting wire. This large current in parallel coil actuates magnetic repulsion mechanism of vacuum interrupter. Due to opening of vacuum interrupter, the current in superconducting wire is broken. By using this equipment, current flow time in superconducting wire can be easily minimized. On the other hand, the fault current is also easily limited by large reactance of parallel coil. © 2008 Wiley Periodicals, Inc. Electr Eng Jpn, 164(1): 52–61, 2008; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20315     

An important factor affecting synergism on coprocessing of Taiheiyo coal with Athabasca oil sand bitumen

A series of mixtures of Japanese subbituminous Taiheiyo coal and Athabasca oil sand bitumen (AOB) with various coal concentrations (0–100 wt%) was coprocessed in a 70 ml autoclave at 420°C for 1 h in the presence of H₂ (50 kg/cm² at room temperature) and sulfided Ni---Mo/Al₂O₂ catalyst. The mixture containing 2 wt% coal produced the largest amount of hexane soluble fraction (HS) and the smallest amount of benzene insoluble fraction (BI). Thus, a synergistic liquid production occurred for this mixture with 2 wt% coal by suppressing the retrogressive reactions which proceeded for pure AOB. The HS obtained from mixtures with 2–30 wt% showed higher H/C ratios and lower heteroatom contents than those obtained from pure AOB and the mixtures with more than 30 wt% coal. The amounts of transferable hydrogen contained in the mixtures were estimated using anthracene as a hydrogen acceptor. The mixtures with 2–10 wt% coal contained higher amounts of donor hydrogen than pure AOB. The HS yield from the various mixtures was correlated with the amount of donor hydrogens contained in the mixtures, except for the mixture with 10 wt% coal. Thus, the important factor which results in synergism is suggested to be the amount of donor hydrogens contained in the feed mixtures.     

Design of wavelength-flattened coupler using a novel diagram

A novel diagram which describes the condition of 3 dB coupler is proposed. Using the proposed diagram, the design of a wavelength-flattened 3 dB directional coupler composed of a uniform coupled waveguide is investigated. Normalized waveguide parameters are introduced to characterize a five-layer planar waveguide. This enables us to generalize the discussion and to reduce the number of parameters required for characterizing a coupled waveguide. A broadband 3 dB coupler having 50±5% coupling ratio over a wavelength range of 1.1-1.7 μm is designed     

Left ventricular regional systolic motion in patients with right ventricular pressure overload

The highly reactive and cytotoxic hydroxyl radical (OH) was found by electrochemical detection to be produced in reactions involving hydrogen peroxide (H2O2) and the nitric oxide (NO) donor diethylamine- NO complex. Using aromatic hydroxylation of salicylate as a specific indicator of OH, three salicylate hydroxylation products were identified; catechol, 2,3- and 2,5-dihydroxybenzoic acid. Four additional compounds were detected but not identified. The interactions of H2O2 and NO represent a biologically feasible reaction mechanism that can account for OH-induced damage in cellular environments where transition metal ions are unavailable for participation in the superoxide-mediated Fenton reaction. The ability of the NO/H2O2 complex to generate OH independently of iron or other transition metals provides a new focus for studies concerned with the origin of tissue-specific damage caused by oxygen-derived species.     

Two-dimensional electrophoretic analysis of humoral responses to culture filtrate of Mycobacterium bovis BCG in patients with leprosy and tuberculosis

Various aspects of our communication are well known to have changed over time (1-3). This article describes a cross-sectional study that examined the acoustic characteristics of two groups of Australian women aged 18-25 years from recordings made in 1945 and 1993 and investigated the possible changes in the voice across generations. Archival recordings from 1945 which had been used in a longitudinal study (4) were compared to recordings made in 1993. The results of this study show that women in 1993 have significantly deeper voices than women of the same age recorded in 1945. The possible factors influencing this change are discussed.     

Modification of mesophase pitch by blending Part 2 Modification of mesophase pitch fibre precursor with thermoresisting polyphenyleneoxide (PPO)

Polyphenyleneoxide was blended in amounts of 5 or 10 wt% into petroleum-derived mesophase pitch to reinforce the pitch fibre before the oxidative stabilization to achieve better handling properties. Although polyphenyleneoxide was fusible but hardly soluble in the mesophase pitch even at a spinning temperature of 350° C, blended pitch could be smoothly spun into pitch fibre 10m diameter, as could the parent pitch. Fibrous polyphenyleneoxide of less than 1m diameter was homogeneously dispersed in the pitch fibre, being arranged along the fibre axis. Such fibrous polyp henyleneoxide reinforced the pitch fibre considerably. The fibrous substances at the centre of the fibre disappeared in the carbonized fibre at 1300° C after oxidation at 250° C, although some short ones were observed in the skin region of the fibre, suggesting that polyphenyleneoxide was co-carbonized to be assimilated with mesophase pitch at the centre of the fibre, where the effects of oxidation may be rather limited. The oxidation reactivity and its mechanical strength after carbonization were slightly lower in comparison with those of the parent mesophase pitch.     

Ozone Contribution in Food Industry in Japan

Ozone has the strongest oxidization effect after fluorine, and this property has been used in sterilization for food and processing plants in Japan. Moreover, there is no fear of toxic residues as with chlorine-based sterilizers and no hazardous trihalomethanes are formed. Based on these advantages, ozone has been used in water and air treatment for food products food materials and food processing plants. Use in the food processing is now increasing in Japan. This paper describes ozone sterilization, introducing sterilization systems and equipment applied to food in Japan.